The oven started at 130°F or less with the door closed, and the temperature climbed less than 10°F in five minutes. The control assumes it is not heating. On older LRE electric models F9 means the oven ran too hot instead.


On electric models we check bake and broil elements for resistance, then put an amp clamp on them, because an element can read fine cold and open up once it heats. On gas models the glow bar igniter has to pull roughly 3.1 to 3.3 amps before the safety valve opens, so a weak igniter that still glows is the most common cause. We measure that draw and the valve coil, which reads only a few ohms.
The oven started at 130°F or less with the door closed, and the temperature climbed less than 10°F in five minutes. The control assumes it is not heating. On older LRE electric models F9 means the oven ran too hot instead.
Check the breaker. An electric range needs both halves of its double breaker on to heat. Gas range: make sure the gas valve behind the range is open and other burners light. Turn the range off at the breaker for one minute, then power it back up and see if the code returns.
On electric models we check bake and broil elements for resistance, then put an amp clamp on them, because an element can read fine cold and open up once it heats. On gas models the glow bar igniter has to pull roughly 3.1 to 3.3 amps before the safety valve opens, so a weak igniter that still glows is the most common cause. We measure that draw and the valve coil, which reads only a few ohms.
Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.