LG APPLIANCE REPAIR Factory Authorized Service Β· Irvine, CA

LG Cooktop Burner Not Working? Causes & How to Fix It

A gas burner clicks but won't light, lights unevenly or makes no spark at all, or an electric or induction element stays cold while the others work.

Call (949) 876-7373 Text Us
βœ… Factory Authorized LG Service Provider πŸ›‘οΈ Licensed & Insured ⚑ Same-Day Appointments πŸ”§ 90-Day Parts & Labor Warranty
LG Cooktop Burner Not Working

Try these quick checks first (free & safe)

  1. Gas: if a burner clicks but won't catch, let it cool, lift the cap and set it back down flat and centered on the burner head. A cap that's off by a few millimeters is the most common reason.
  2. Gas: if none of the burners light, make sure the gas shutoff behind the range is open and other gas appliances in the house are working.
  3. Gas: wipe up boil-overs around the burner and igniter and let everything dry before trying again. A wet igniter clicks forever.
  4. Induction: hold a magnet to the bottom of your pan. If it doesn't stick firmly, or the bottom isn't flat, the zone won't heat. Most stainless and all aluminum or copper pans won't work.
  5. Electric: if all elements are dead, check the double breaker in the panel. One half tripped can leave the clock working and the cooktop cold.

What actually causes it, from LG technicians

Burner cap or head out of place

On a sealed gas burner the cap has to sit flat and centered or the flame can't carry from the igniter around the ring. You hear clicking, smell a little gas, and nothing lights.

Igniter switch or spark module

If a burner makes no spark at all, the switch behind that knob or the spark module that feeds all the igniters has failed. A stuck switch also makes everything click non-stop.

Dirty orifice or wrong gas setup

Grease and soot in the small brass orifice give a weak, yellow or one-sided flame. A range moved from natural gas to propane (or back) needs the regulator flipped and every orifice changed. Skip that and the flames will be wrong on every burner.

Burned-out radiant element

On electric ranges a single element that stays cold is usually open inside. A good single element reads roughly 20 to 50 ohms, and dual elements have two circuits that each need to check out.

Loose terminal block or open limiter

When every element is dead, it's often power: a loose or burned lug at the terminal block, or a limiter thermostat that opened and cut the whole cooktop.

Induction board, coil or fuse

Induction zones that won't heat with good cookware point at the power board, the inverter or the coil. An open fuse on the induction board usually means one coil has shorted, and that coil, its inverter and its power board get replaced together.

What it looks like

How we diagnose it on a service call

Gas burners: supply, spark, flame

If no burner lights we start at the gas supply. If they click but don't light, we check cap seating and burner head alignment first. If there's no spark, we check for 120V at the igniter switches and at the spark module, then test the switch on that knob. We also look at the orifice, clean it if it's sooted, and confirm the range is set up for the gas you actually have.

Electric elements: resistance and voltage

With the power off we measure each element. A single element typically reads 20 to 50 ohms depending on size. On dual elements we read each circuit separately, about 40 ohms and 35 ohms on common LG parts, give or take 10 percent. Then with power on we check for 240V (or 208V in some condos and apartments) at the element when it's switched on. Good element with no voltage means the switch, the board or the wiring.

When the whole cooktop is out

We measure at the terminal block: about 120V from each leg to neutral and 240V across the two legs. We tighten and inspect the lugs, because a loose lug heats up, discolors and eventually burns. Then we check the limiter thermostats on the schematic that can cut power to just the cooktop.

Induction zones

First the pan: it has to be magnetic and flat. If the zone can't lock on to the pan it's either the cookware or the wrong pan size for that coil. With good cookware we check the fuses on the induction boards, and if one is open we test each coil for a short to ground before replacing anything, so the new board doesn't blow on the first use.

πŸ”§ When it's time to call a pro

Most clicking gas burners we see just have a cap that's not seated or a wet igniter. Beyond that it's a spark switch or the spark module, both reasonable repairs. On electric and induction tops we measure before we order, because an element, a switch and a board can all look the same from the outside.

LG Cooktop Burner Not Working: FAQ

Why does my LG gas burner keep clicking after it lights?+

Usually moisture or food around the igniter, or a cap that isn't seated so the flame doesn't touch the electrode. If it clicks even with all knobs off, a burner switch is stuck and needs replacing.

Why won't my LG induction cooktop heat my pan?+

Induction needs magnetic, flat-bottomed cookware sized for the zone. Cast iron, enameled steel and most magnetic stainless work. If a magnet sticks and the zone still won't heat, it's a board or coil problem.

Is it normal for the knobs and front of my range to get hot?+

Warm, yes. The front panel, knobs and handles are designed to stay under set limits as long as the oven door closes and seals properly. If the knobs get too hot to touch, a bent hinge or a door that doesn't seal is the usual cause, and that should be repaired.

Related LG repairs

πŸ”₯ LG Oven Not Heating β†’ 🍰 LG Oven Not Baking Evenly β†’

LG Cooktop Burner Not Working, service in your city

Aliso Viejo Anaheim Brea Buena Park Costa Mesa Cypress Dana Point Fountain Valley Fullerton Garden Grove Huntington Beach Irvine La Habra La Palma Laguna Beach Laguna Hills Laguna Niguel Laguna Woods Lake Forest Los Alamitos Mission Viejo Newport Beach Orange Placentia Rancho Santa Margarita San Clemente San Juan Capistrano Santa Ana Seal Beach Stanton Tustin Villa Park Westminster Yorba Linda

Fix Your LG Cooktop Burner Not Working Today

Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.

Call (949) 876-7373 Text Us
⚑ $25 OFF For new & referred customers