The oven won't reach temperature, takes forever to preheat, bakes unevenly, or a burner won't light.

Electric ovens: elements burn out visibly (blisters, breaks) or fail quietly. Fast same-visit replacement.
The #1 gas-oven fault: the igniter glows but never gets hot enough to open the gas valve, so the oven heats late, unevenly, or not at all.
The oven overshoots, undershoots, or shows F-codes. A sensor swap plus calibration check fixes it.
Uneven baking and long preheats on convection models when the fan motor dies.
The board's heat relays stick or burn, common after power surges. We test the board's outputs before replacing anything.




| Code | Meaning |
|---|---|
F9 | Oven failed to reach temperature |
F7 / F11 | Stuck key / shorted keypad |
F19 | Relay board communication fault |
F1 / F2 | Control / sensor circuit fault |
We write down every F-code first. On electric ranges we check both legs of the 240V supply at the terminal block, because one dead leg leaves the display and lights working but no heat. On gas ranges we check that gas reaches the range and the other burners light.
We measure the bake and broil elements with a meter, even the hidden bake element under the oven floor. Then the temperature sensor: on most LG ovens it reads around 1,100 ohms at room temperature. Off by a lot means the oven is being lied to about its own heat.
The most common gas oven fault is a weak igniter. It glows, so it looks fine, but it doesn't draw enough current to open the gas valve. We measure the current with a clamp meter instead of judging by the glow.
Only when the elements, the sensor and the igniter all test good do we look at the board's relays and outputs. Boards are expensive, so we prove the board is bad before we replace one. Before Thanksgiving, don't wait for the oven to quit with a turkey inside.
Oven repairs mix gas, 240V electricity, and control electronics, this is a technician's job. We repair LG ranges, wall ovens, and cooktops, including the ProBake and InstaView lines, with factory parts.
Usually a weak igniter (gas) or a failing element/sensor (electric). LG ovens that once preheated in 10β12 minutes and now take 25+ have a failing component, not a software issue.
F9 means the oven didn't reach target temperature in the allowed time, pointing at the igniter, element, or gas supply rather than the board itself. It's one of the most common codes we fix.
Yes, ranges, slide-ins, wall ovens, and cooktops, gas and electric, including induction. Same warranty: 90 days parts and labor, longer on select parts.
If it preheats slowly, shows an F-code now and then or bakes unevenly, yes. Those faults rarely fix themselves and they tend to get worse under a long, hot holiday bake.
Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.