The display stays dark and buttons do nothing, the screen flickers or the dial turns without changing anything, or a dryer lights up but won't start.

Tripped breakers, a tripped GFCI and loose outlets cause a large share of these calls. Electric dryers need 240 or 208 volts, and if one leg is missing the display may not light at all. Gas dryers run on a regular 120 volt outlet.
The power switch on many LG dryers is a normally closed contact that opens when you press it, and it can fail. On WT7300, WT7800, WT7880 and WT7900 top loaders, the power button can stop touching the board, and the display assembly is replaced.
The main board sends low DC voltage up to the display. If that voltage arrives and the screen stays dark, the display board is bad.
If the main board has 120 volts coming in but doesn't send DC voltage to the display, the board is the problem. Power surges are a common cause.
Power passes through a small filter board before reaching the main board. A failed filter or a damaged cord stops everything downstream.
A dryer with a door switch fault shows dE and won't start, even though it has power. Models with the digital dial can lose the knob or its LCD, and that part is replaced on its own.




| Code | Meaning |
|---|---|
nP | No power on one 240V leg (electric dryer) |
PS | Power supply or wiring polarity problem |
dE | Dryer door switch, the door isn't sensed as closed |
PF | Power failure during the cycle |
We read the outlet first, then read it again while trying to start a cycle. A voltage that sags when the machine draws current means a weak breaker, a loose connection or a bad receptacle in the house, and that's a job for an electrician, not a new board. On electric dryers we check each leg to neutral, since the control needs 120 volts on L1 to power up.
From the outlet we check the noise filter board, then the incoming 120 volts at the main board. On front load washers there should be line voltage at the main board even before the power button is pressed. No voltage at the board input with good power at the cord means the filter or the cord.
On LG dryers we measure the power button circuit: about 120 volts across it at rest, dropping to zero when pressed, and we ohm-check the switch itself. At the display connector we look for roughly 12 volts DC (10 to 15 on dryers) and 5 volts DC. Top load washers send about 16.5 volts DC up to the display.
If the DC voltages reach the display and it stays dark, the display board is replaced. If the main board gets line voltage but sends nothing up, the main board is replaced. For a dryer showing dE we check door switch continuity with the door closed: no continuity means a new switch.
A dead LG washer or dryer is very often a breaker, a GFCI or an outlet, so check those before you book a call. When it is the machine, we trace the voltage step by step and replace only the board that's actually failed. A wrong guess on control boards is expensive, and we'd rather spend ten more minutes with the meter.
Plug it straight into the wall, reset any GFCI outlet and flip the breaker off and on. Test the outlet with a lamp. If the outlet works and the washer is still dead, the problem is inside, usually the display, power button or main board.
If the display lights but the drum won't turn, check that the door is fully closed and the lint filter is seated. A dE code points to the door switch. On electric dryers, one tripped half of the 240 volt breaker can also leave the dryer half working.
Yes. A surge can damage the noise filter or the main board. If the machine went dead right after a storm or an outage, tell us when you book, it helps us bring the right parts.
Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.