LG APPLIANCE REPAIR Factory Authorized Service · Irvine, CA

LG Dishwasher Error Codes: What Each Code Means

An LG dishwasher stops and shows a two letter code when it sees a problem with water, heat, draining or a motor. A clogged filter or a closed valve causes more of these codes than you might think, so start with the easy checks below. If the code comes back, our factory authorized LG repair technicians can track it down.

Call (949) 876-7373 Text Us
CodeNameWhat the dishwasher detected
AE / E1Leak detected in the baseWater reached the float switch in the base pan under the tub, so the dishwasher stops and runs the drain pump. Some models show AE, others E1.
OEWater not drainingThe main board did not see the tub empty in time.
IEWater not coming inThe board did not see enough water come in, based on pulses from the flow meter.
HEWater not heatingThe water did not heat, or the tub overheated past about 194 degrees F.
tEWater temperature sensor faultThe board reads the water temperature sensor as open or shorted. Very hot incoming water, around 194 degrees F, can also set it.
LEWash motor faultThe board could not run the wash pump motor properly.
FEToo much waterThe board saw too much water come in, so it runs the drain pump to get rid of it.
nESpray diverter motor faultThe motor that switches water between spray arms (the vario motor) is not being detected as turning.
bEToo many sudsThe machine detected heavy foam in the tub.
PFPower was interruptedPower cut out while the dishwasher was on. It is a notice, not a fault, and pressing Power resumes the cycle.
CLControl lock is on, not a faultChild lock is active, so buttons other than Power and the lock button do nothing. The display alternates CL with the time remaining. The lock stays on after the cycle ends.
F31Heated dry fan faultThe fan for heated air dry is not running.
F35Heated dry temperature sensor faultThe temperature sensor for heated air dry reads out of range.
F37Auto open door motor faultThe motor that pops the door open at the end of a cycle for better drying has a fault.
L0 / L1 / L2 / L3 / L4Rinse aid setting, not a faultThe display is showing the rinse aid level. Factory setting is 2, with 5 levels from L0 to L4.
P1 / P2 / P3 / P4 / P5 / P6 / P8 / P9Download cycle number, not a faultThe display shows which downloaded cycle is loaded. The default download cycle is P1, Pots and Pans. You can change it through the ThinQ app.

Code Keeps Coming Back?

Tell us the code and model, we usually know the fix before we arrive. Same-day across Orange County.

Call (949) 876-7373 Text Us
⚡ $25 OFF For new & referred customers