The board could not run the wash pump motor properly.


On newer models we read about 24 ohms (plus or minus 10 percent) between any two of the three motor wires and look for 50 to 170 volts AC from the board, depending on speed in test mode. A meter that reads inverter pulses is needed. A stuck or damaged impeller or an open winding means a new wash pump assembly. Older models (about 2016 and before) may use a hall sensor we test separately.
The board could not run the wash pump motor properly.
Remove and clean the filter. Look for glass or bones near the pump. Turn power off at the breaker for 5 minutes, then restart.
On newer models we read about 24 ohms (plus or minus 10 percent) between any two of the three motor wires and look for 50 to 170 volts AC from the board, depending on speed in test mode. A meter that reads inverter pulses is needed. A stuck or damaged impeller or an open winding means a new wash pump assembly. Older models (about 2016 and before) may use a hall sensor we test separately.
Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.