The board does not see the door switch circuit closed, so it will not lock the door or start.


We test the door lock assembly switch and solenoid and look at the strike and hinge for sagging. Low house voltage can also cause dE, so we measure the outlet under load. A drain pump with shorted windings (under about 3 ohms instead of 10 to 20 on 120 volt pumps) can drag the circuit down and trigger dE too, so we check it before replacing the lock.
The board does not see the door switch circuit closed, so it will not lock the door or start.
Open the door and close it firmly until it clicks. Remove any clothing caught in the door gasket. Check that the power cord is pushed fully into a tight outlet. Unplug the machine for 10 minutes, plug it back in and run a short cycle to see if the code returns.
We test the door lock assembly switch and solenoid and look at the strike and hinge for sagging. Low house voltage can also cause dE, so we measure the outlet under load. A drain pump with shorted windings (under about 3 ohms instead of 10 to 20 on 120 volt pumps) can drag the circuit down and trigger dE too, so we check it before replacing the lock.
Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.