LG APPLIANCE REPAIR Factory Authorized Service · Irvine, CA

LG Washer OE Code: Water not draining in time

The control watched the water level during drain and it did not drop fast enough. Something is slowing the water on its way out, or the pump is not moving it.

Call (949) 876-7373 Text Us
✅ Factory Authorized LG Service Provider 🛡️ Licensed & Insured ⚡ Same-Day Appointments 🔧 90-Day Parts & Labor Warranty
LG washer

Try these quick checks first (free & safe)

  1. Turn the washer off, put a towel and a shallow pan under the small door at the bottom front, and clean out the drain pump filter.
  2. Pull the washer out and check the drain hose for kinks or a crushed spot behind it.
  3. Make sure the hose goes only about 4 inches into the standpipe and is not taped airtight.
  4. Check that the hose outlet sits no higher than 96 inches above the floor the washer stands on.

What our technician checks

Our technician starts at the pump housing and the tub to pump bellows, where socks and coins like to hide, then checks the pressure sensor tube for a blockage. Newer DC drain pumps should read roughly 1.5 to 4 ohms per winding, older 120 volt pumps about 10 to 20 ohms. We run the pump from the test program and confirm the board actually sends it power before deciding between a pump, a harness or a control board.

LG washer repair in Irvine and Orange County →

LG OE code: FAQ

What does the OE code mean on an LG washer?+

The control watched the water level during drain and it did not drop fast enough. Something is slowing the water on its way out, or the pump is not moving it.

Can I clear the OE code myself?+

Turn the washer off, put a towel and a shallow pan under the small door at the bottom front, and clean out the drain pump filter. Pull the washer out and check the drain hose for kinks or a crushed spot behind it. Make sure the hose goes only about 4 inches into the standpipe and is not taped airtight. Check that the hose outlet sits no higher than 96 inches above the floor the washer stands on.

What does a technician check for OE?+

Our technician starts at the pump housing and the tub to pump bellows, where socks and coins like to hide, then checks the pressure sensor tube for a blockage. Newer DC drain pumps should read roughly 1.5 to 4 ohms per winding, older 120 volt pumps about 10 to 20 ohms. We run the pump from the test program and confirm the board actually sends it power before deciding between a pump, a harness or a control board.

Other common LG Washer Error Codes

IE: Not enough water coming in UE: Load out of balance LE: Motor cannot turn the drum CE: Motor drawing too much current dE: Door not detected as closed PE: Water level sensor fault FE: Too much water in the tub tE: Water temperature sensor fault AE: Water in the base pan PF: Power was interrupted CL: Child lock is on

LG Washer Showing OE?

Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.

Call (949) 876-7373 Text Us
⚡ $25 OFF For new & referred customers