The pressure sensor that tells the board how much water is in the tub is reading open or shorted, so the washer cannot fill or drain correctly.


We check the sensor plug at both ends, then measure about 20 to 25 ohms across the sensor from the main board with power off and roughly 2.5 to 3 volts DC on its signal pins with power on. A pinhole in the thin air tube gives erratic readings, and since that tube comes only with the sensor, the assembly is replaced together.
The pressure sensor that tells the board how much water is in the tub is reading open or shorted, so the washer cannot fill or drain correctly.
Turn the washer off and back on and start a new cycle. Unplug the machine for 10 minutes, plug it back in and run a short cycle to see if the code returns. If it repeats, stop using the washer so it does not overfill.
We check the sensor plug at both ends, then measure about 20 to 25 ohms across the sensor from the main board with power off and roughly 2.5 to 3 volts DC on its signal pins with power on. A pinhole in the thin air tube gives erratic readings, and since that tube comes only with the sensor, the assembly is replaced together.
Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.