The board tried to spin the direct drive motor and the rotor did not move or the hall sensor did not report the movement.


We turn the drum by hand and listen. A grinding feel points to tub bearings, a click points to a loose rotor bolt or cracked rotor. Stator windings should read between about 5 and 15 ohms. On models with a hall sensor we check about 8 to 12 kilohms per leg and 10 to 15 volts DC supply, then watch for pulses while turning the drum by hand.
The board tried to spin the direct drive motor and the rotor did not move or the hall sensor did not report the movement.
Make sure nothing is wedged between the drum and the door seal. With power off, turn the drum by hand. It should move freely and quietly. Do not overload the drum, especially with wet bedding. Unplug the machine for 10 minutes, plug it back in and run a short cycle to see if the code returns.
We turn the drum by hand and listen. A grinding feel points to tub bearings, a click points to a loose rotor bolt or cracked rotor. Stator windings should read between about 5 and 15 ohms. On models with a hall sensor we check about 8 to 12 kilohms per leg and 10 to 15 volts DC supply, then watch for pulses while turning the drum by hand.
Factory authorized LG repair, parts on the van, 90-day warranty. Same-day across Orange County.